Logitech Z506 demise and disassembly

Back in varsity I had a set of 2.1 channel Logitech speakers. They were great, simple and provided good sound. Alas one day they stopped working, never found out why, even after taking it apart (one had to saw open the wooden sub box) and getting several friends and family members to analyse it. In any case, I ended up purchasing a Logitech Z506 5.1ch set to replace them.

And they’ve done me well. Until recently. I’ve had them for about 3 years; I would have expected a longer life but I fear the recent spate of load shedding (and related grid instability) might have given them a knock (oddly I think it’s what happened to my last set too).

Anyway, they stopped working unexpectedly, so logically I took them apart. You can see the process below. It’s quite nicely put together, but also not with the intent of it being taken apart again later.

In any case I looked around a bit and saw that what I still believe is a fuse was not letting any current through (marked T3.15A250V). So, lacking a replacement fuse, I shorted the fuse and thought I’d fixed the problem, alas I fear there was another reason why the fuse had gone as I plugged the power back in.

Cue loud bang, my lights going out and enough flames to give me a fright. 10 o’clock at night, I made my way to my tripboard and reset the plugs, unfortunately I had also managed to trip the switch in my landlord’s house. Fortunately they were still awake and didn’t ask too many questions as I asked if I could check their tripboard quickly.

So I’m once again in the market for new speakers (edit, managed to revive them, see below), but for others who might have more luck than me, here are instructions to disassemble.

Unscrew the 10 screws on the backpanel. Unscrew the 4 screws mounting the speaker to the bottom of the box. Pull the speaker out. You will notice bendy wire clips stapled to the case holding cables in place, loosen these as required.

Undo screws on back and bottom of speaker

Undo screws on back and bottom of speaker

If you have small hands you can unplug the speaker, but otherwise rest it on top. The backpanel slides out, but there is a bit of double-sided tape holding it in place at the back under the panel. You can release this by pulling the PC-Board away from the side of the box. You can then pull the backpanel and PCB out. This will let you unplug the two plugs on the power supply.

Plugs to unscrew and mounting points

Plugs to unscrew and mounting points

With the main board out, you can loosen the two screws holding the PSU in place and slide it out.

partsSimple as that, above you can see where the fuse I shorted was, and also a bit of the transformer which I think I burnt out. Oops :(

Update:
A bit of searching led me to believe that I could fit a replacement power supply and all would be alright. I had a spare laptop power supply (90W, 19V) lying around, and I wired this up. So far it has been running like that for several months.

It is also possible to buy direct replacement boards, for example here.